Install the Battery
The Spinshot remote watch requires a CR2032 battery.
To install the battery open the back of the remote watch by unscrewing the four screws.
Slip the battery into the battery housing with the positive sign (+) facing outwards. Then reattach the back and tighten the screws.
How to pair the Spinshot Remote Watch to your machine
- The Spinshot Remote uses a BT connection to pair with your machine. Power on your machine
- Press the remote watch button to connect.
- The red light will blink while the watch is connecting to the machine.
- The red light will go out once the machine is connected.
- When the button is pressed the light will flash once to indicate the command has been sent.
- If the red light starts blinking this indicates the signal has been lost and it is trying to reconnect.
- If the machine is turned off the remote watch will go into sleep mode. You do not have to turn off the Remote Watch.